Control flow step errors

The errors on this page can occur with control flow steps such as Jump to another step and Continue only if a condition is met.

Jump target step does not exist

Error: Jump to another step: Step number given does not exist in this axiom. The error can also appear as Step number given does not exist in this axiom.

Problem: The step number set in Jump to step on a Jump to another step step doesn't match an actual step in the automation. This often happens after deleting or reordering steps.

Fix: Open the Jump to another step step and update Jump to step to a step that exists. After moving steps around in an automation, check every jump step still points where you intended.

Continue condition did not pass

Error: Continue condition check did not pass.

Problem: A Continue only if a condition is met step's condition evaluated to false (or to true if Reverse condition was on), so the automation stopped at that point.

Fix: Watch the run to see what value Data to check actually contained when the step fired, then adjust Condition to check to match the data you're seeing. If the failed condition should be a clean stop rather than an error, leave Fail if condition not met off; the automation will end without an error.